Tucker GTR3, Инструкция по сборке, установке и эксплуатации, Страница: 4 / 16

4
ROASTING HOOD ASSEMBLY
INSTRUCTIONS
•
Roasting Hood body
•
Handle
• Rear Cooking Shelf
• Roasting Rack
•
Roasting Pan
•
GTR BBQs can be installed with either a Flat
Hinged weather cover/ Lid or a Roasting
Hood.
•
Make sure to read any separate instructions
on Assembly, Installation and Operation of
the GTR Barbecue and / or Wok Burner if
they are to be fitted to the BBQ.
•
If you have a Flat Hinged Weather Cover/
Lid, attach the Lid onto the back of the BBQ
with the Phillips head bolts provided.
Tools required for assembly – 10mm spanner
Check you have all the correct components as
listed below.
1. The Roasting Hood can now be fitted.
Remove any packaging, cable ties and
components from inside the Hood. You
should have a Rear Cooking Shelf, Roasting
Rack, Drip Pan and Handle for the Roasting
Hood inside.
NOTE:
The Roasting Hoods are packaged inside
the Cabinet Trolley for transport, they cannot be
removed unless the Doors of the Cabinet Trolley
are removed first.
If you have chosen a Roasting Hood with
your GTR Barbecue and Cabinet Trolley you
may need to unhinge and remove the Doors
completely from either side of the Cabinet to
allow the removal of the Roasting Hood.
TOOLS NEEDED
ROASTING HOOD PARTS LIST
2. First attach the Handle onto the front of the
Roasting Hood with the nuts provided, you
will find the nuts and washers attached to
the handle ends.
3. To fit the Roasting Hood onto the BBQ, the
base of the Roasting Hood has 4 x locating
tags that fit into corresponding slots on the
top of the BBQ.
4. Slide the angled tags on the front of
the base of the Roasting Hood into the
corresponding slots in the front of the BBQ.
You will need to angle the base of the
Roasting Hood down toward the front of the
BBQ so that it allows the tags to slot into the
slots in the BBQ easier.