Tubeline TL60ECV, Руководство оператора

Страница: 31 / 64

7-2 Section 7: Operation - TL60ECV
Auto Wrap Mode
1. Switch balewrapper control screen to auto wrap mode. Refer to pg.6-1 .
2. Use lifting machine to set bales on the bale deck. Bales must be placed on top of bale trigger to
start the auto wrap cycle.
3. As bale ram returns to front of balewrapper continue placing bales onto bale deck until reaching
the last bale of row.
Steering
The TL60ECV balewrapper is equipped with electric over hydraulic steering to keep the balewrapper
headed in desired direction or to direct the wrapper around obstacles. For steering operation refer to
Control Panel Functions , pg.5-1 .
CAUTION: Wrap on flat even surface to prevent balewrapper from drifting out of line.
NOTE: Prevent air pockets in bale row by avoiding sharp turns.
Steering can be done remotely with optional remote control. Refer to pg.13-1 .
Manual steering is not required with optional laser guidance system. Refer to
pg.20-1.
Stopping Cycle
If a problem occurs after the cycle has started in auto wrap mode, press Stop Cycle button on control
screen . Refer to pg.6-1 .
Press control panel emergency stop to completely shut down balewrapper. Refer to
pg.5-1
.
Optional Remote Start
Push the STOP button on the hand unit to stop the cycle. After the problem is rectified, finish the rest
of the cycle in the manual wrap mode and then return to auto wrap mode. If you press start button on
the hand unit it will also start the ram forward again but if the ram has passed the hoop start switch
the hoop will not start with the ram. Refer to
pg.13-1
.