TubeDepot JTM45+, Инструкция по сборке

Страница: 32 / 45

Turret Board Installation
Step 1 – Route the two wires coming from turrets T43 and T37 around the back side of the
turret board, coming out from the board around turrets T48 and T42.
Step 2 – Hold the above two wires in place and physically mount the completed turret board
into the chassis onto the standoffs and secure in place with four #6-32 x 3/8” screws.
Step 3 – Solder the wires from the turret board to the appropriate chassis locations. Trim the
wires as needed (drawing 7.1). It is a good idea to make these connecting wires as short as
reasonably possible.
Step 4 – Route the wires going to the front panel controls underneath the buss wire, toward
the chassis.
Step 5 – Route the wires going to the power supply along the edges of the chassis to reduce
potential noise.
Step 6 – Install a short (2”) 20 AWG, black wire between the buss ground of the turret board
and the buss ground across the back of the pots.
Step 7 – Connect the ground wires from the input jacks and master volume to the buss
ground of the turret board.
Step 8 – Connect the longer ground wire from the G1 grounding terminal to turret T31.
Step 9 – Connect the shorter ground wire from the G1 grounding terminal to turret T53.
7.1
Assembly and Wiring
Turret Board / Chassis
7
28 TubeDepot.com