TubeDepot JTM45+, Инструкция по сборке

Страница: 13 / 45

Step 7 – Shrink the heat shrink in place with a heat gun (photo 4.3b)
Step 8 – Install the remaining 3” heat shrink length over the tech flex at the
opposite end of the twisted pair near the cut end.
Step 9 – Shrink the heat shrink in place with a heat gun.
Step 10 – At the opposite end of the twisted wire pair, strip back the insulation
¼” and tin these two wires.
Step 11 – Solder these wires to the terminals of the speaker; the white wire to the “+” terminal
and the black wire to the “-” terminal (photo 4.3c).
Mounting the Speaker in the Cabinet (Combo Cabinet)
Step 1 – Remove the four speaker mounting screws
from the speaker baffle board.
Step 2 – With speaker in hand, carefully align the
speaker mounting holes to the baffle board mounting
holes (I recommend installing the speaker with
connecting terminals on top).
Step 3 – Install a single #8 flat washer on each of the
four mounting screws prior to installation.
Step 4 – Install the four mounting screws through the
speaker mounting holes into the baffle board. Firmly
tighten down.
4.4
CAUTION
Be careful when applying heat to the heatshrink, especially at the point where the techflex
and heatshrink meet. The techflex will quickly melt if excess heat is applied.
photo 4.3b
photo 4.3c
photo 4.4a
The speaker that comes with the combo kit could be one of several different speakers
(not just Celestion as shown).
NOTE
TubeDepot.com 9