Tube-Line TL5500 2004, Руководство пользователя

Страница: 9 / 71

Installation Of Plastic
Plastic from factory has a natural
tack on inside. In event of plastic being stored for an extended period of time, the
tack may migrate to opposite side. To test for tacky side, fold plastic inside to inside and pull apart. Fold opposite
(top to top) to determine tackier side.
The roll of plastic should be installed with
tack on inside of the plastic film next to the bale of silage. The plastic
then passes over the slave roller and is threaded through the two metal rollers on the tensioner as shown in the
diagram.
The two metal stretcher rollers rotate at different speeds. This causes the plastic to be stretched. It is very important
that the plastic goes over the slow roller first and the faster roller second.
If there is any question on which is the faster roller:
1. Place a pen mark on each roller and rotate one roller one turn.
2. Check the location of the mark on the other roller.
If it has advanced further, then it is the fast roller.
If it has advanced less, then it is the slow roller.
When the plastic is installed correctly, it should stretch tight on the bale to form a smooth tube.