Tube-Line TL5500 2004, Руководство пользователя

Страница: 8 / 71

Bale Size
ROUND BALES The Model TL5500 will wrap bales of up to 5½’ wide and up to 5’ high. It will wrap all sizes
smaller then these dimensions as well.
Remember when making big bale silage, the bales will be heavier then dry hay. This puts extra strain on loading and
transporting equipment. Also, bales will be heavier when feeding out and may have to be moved on wet ground or
snow. As a result, most operators reduce silage bale diameters to 4-4½’, even though the wrapper and baler will
handle larger bales.
Square Bales
The Model TL5500 will wrap most sizes of square bales. The length should be reduced to 5’. This is to allow the
bales to be placed on the bale receiver. This may also be the maximum length advisable to handle big square bales of
silage.
Bales which are approximately 4’ wide and 2’ high can be stacked two high for wrapping.
Bales which are approximately 3’ wide and 3’ high do not stack well. These may be wrapped in a single tier of
bales.
Big square bales must be wrapped manually, or with the remote control kit. When stacking two high, the first bale
would activate the automatic device prior to loading the second bale.
Extra care must be taken to ensure that extra film is applied at the bale joints if the bales are uneven.
Recommended Operating Procedure
We suggest the following method of operating the TL5500 Tube-Line Wrapper.
-Park the wrapper where you want the end of the row to be, facing in the appropriate direction.
-Fold front section of tongue and insert bracket in hydraulic steering pin.
-Start the engine
-Undo tail tiebar hairpin and lay bar over rear axle and put hairpin back into place to prevent loss.
Caution: To Prevent Injury—Prior to lowering wrapper tail section, be sure to check that all bystanders are standing
clear.
-Lower the tail section using the manual operating valve