Tube-Line TL5500 2004, Руководство пользователя

Страница: 17 / 71

Notes
Electric Solenoid valves can be manually operated by pushing a small punch into the end of
spool and holding it in.
Caution Stay Away From Hoop When Engine Is Running
Inside of Control Panel , control relays are numbered CR1 to CR5 from left to right. Relay CR1
is wired to table trigger. CR1 will activate solenoid valve to extend ram cylinder. CR2 is wired to
switch at the front slider, when ram is extended to this switch CR2 will close, energizing the
wrap motor valve. Ram cylinder will extend and wrap motor will turn until ram comes in
contact with slider switch at rear, then CR1 and CR2 will turn off and CR3 will turn on. Wrap
motor will stop and ram cylinder will retract until ram cylinder trips limit switch at front end of
table. All controls will then turn off.
Testing can be done by pushing trigger plate and wait until machine goes through cycle, or you
can push small square button on the front of relay 1 and let machine go through cycle.
When control relays are activated a small light goes on inside the relay.
When running machine through the cycle and wrapper motor or the cylinders do not work,
check flowcontrol valve to see if flow is going to both motor and cylinder. Engine is stopped by
grounding ignition, in case of ignition failure make sure that stop switch wire is not grounded
to frame and engine switch is not in stop position.
Steering is controlled by switch right/left on control panel through CR4 and CR5 activating coil
A or B on steering solenoid valve.