Additional midi control
If applicable, the following parameters can be controlled additionally:
•
Poly-synth filter cutoff. A bipolar control. (All SK-Synths)
•
Poly-synth filter resonance (All SK-Synths)
•
Sustain ON/OFF (SK20, SK30, SK50)
•
Solo synth filter cutoff (SK30, SK50)
2
•
Solo-synth Portamento ON/OFF (SK30, SK50)
•
Solo synth Aftertouch (SK30, SK50)
The midi controller numbers for these parameters can be found in the MIDI CC chart
below.
The sustain control acts analogous to the external sustain input. In order to use it, activate
the SUSTAIN function of the organ or Poly-synth instrument. You can then
turn off
the
sustain via midi.
Similarly, the portamento can only be turned off via midi. Set a non-zero portamento time
in the SOLO section, then use midi to turn portamento on or off.
Parameter
Midi CC
Range
Poly-synth filter cutoff
74
Bipolar 64 = middle, no change
Poly-synth resonance
2
71
0 - 127
Sustain
64
0-63: no change, 64 – 127: OFF
Solo synth filter cutoff
2
71
0 - 127
Solo-synth Portamento
65
0-63: no change, 64 – 127: OFF
Solo-synth Aftertouch
0 - 127 aftertouch amount
2 For the synths with built in SOLO section, it is possible to control Poly-Synth resonance OR Solo-Synth
cutoff, but not both. This is a choice you need to make during installation.
