5
䠒
䠒䠊
Installation
䠒䠊䠍
Environment
Install Shock Relay in the following environment.
Caution
●
Keep Shock Relay free from lint, paper, wooden
chips, dirt, dust, metal scrap, etc.
㻌
Fire, Accident Risk
䠒䠊䠎
㻌
Install with Screw
Pull out mounting plate and install Shock Relay to the panel.
䠒䠊䠏
Install to DIN rail
While pulling the hook to the arrow direction, install Shock Relay to 35mm DIN rail.
When remove, pull the hook to the arrow direction with flathead screwdriver.
㻌
㻌
㻌
䠓䠊
Wiring
䐟
Connect power supply to commercial power source. If device with harmonic noise, such as
inverter is used, install an isolation transformer.
䐠
Remove terminal cover and use crimp terminal to connect terminal block and wire.
When connecting without crimp terminal, tightening torque of 0.4~0.6N
䞉
m(
䈜
) is recommended
to avoid screw damage
.
Terminal block specification: M3.5 screw, tightening torque
䠖
0.8~1.2N
䞉
m
㻌 㻌 㻌 㻌 㻌 㻌 㻌 㻌 㻌 㻌 㻌 㻌 㻌 㻌 㻌 㻌 㻌 㻌 㻌 㻌 䈜
tightening torque without crimp terminal
䠖
0.4~0.6N
䞉
m
Appropriate wire size
䠖
ISO 0.75
䡚
4mm
2
, AWG
䠀
18
䡚
12
㻌
75
Υ
Copper wire, 2 wires are
connected to 1 terminal.
䐡
When wiring is finished, put back terminal cover, and check the following.
a.
Is there any misconnection?
b.
Have you forgotten to complete any connections?
c.
Are there any abnormal conditions such as short-circuit or ground fault?
㻌
WARNING
●
Wiring must be performed by electricians.
●
Power Off before starting.
㻌
Shock Risk
䟿
䟿
䠒䠏㻌
㻞㻙㻹㻠㻌
㻹㼛㼡㼚㼠㼕㼚㼓㻌㼜㼘㼍㼠㼑 㻌
䈜
