TST-770 WSD Full Line Manual-RevA
© 2021 Truck System Technologies and Pressure Systems International Inc. All Rights Reserved Worldwide.
(770) 889-9102 M-F 9-8pm, Sat 9-2pm EST
Page 34
REPEATER
The repeater is an integral component to your TPMS system.
The repeater is used to strengthen/amplify the sensor
signal to the display. A repeater is packaged with this
system.
1. The repeater is wired to a 12V source that will be
constant while driving.
2. The repeater comes with two wires, one red (+) and
one black (-). Simply connect the red wire to a positive
source and black wire to a ground or negative source.
3. The repeater is weather resistant. No additional setup
is needed for the repeater.
Motorhome Installation
We recommend installing the repeater in one of the rear basement compartments where
there is a 12v power source. Mount the unit inside the bay but against the outer wall. Do
not put the repeater in the engine compartment because of excessive heat. Do not put
the repeater in the rear closet because the metal in the mirror will block the signal.
5th Wheel Installation
We recommend installing the repeater in or near the battery compartment under the front
overhang. Mount it with hook & loop fastener or two-sided tape to the inner, exterior wall.
An alternate mounting place is on the top of the pin-box. Use industrial two-sided tape
and mount the repeater on the upper slope of the pin-box. Connect the positive lead to
the break-away switch (which has 12v power while driving). Ground the negative lead to
complete the circuit.
Travel Trailer Installation
We recommend installing the repeater in the battery box on the front of the trailer. If the
battery box is metal, connect the lines to the battery, then run the lines outside of the box
and mount on the side of the battery box or the front tongue of the travel trailer.
Note:
The red light on the repeater will illuminate “constant or blinking” (the repeater will
illuminate with a constant light when power is applied, once the display is on and the
sensors are reporting. The light will blink occasionally when transmitting information
to the display).
If
the light is not on, check your connections, source power or the in-line fuse on the
positive lead of the repeater for issues.
Repeater
Failure to install the repeater could void the warranty coverage.
Back To
