Features of the DS500 CAN vehicle security system
in version DS500 CAN U is ultrasonic sensor included.
2 separate inputs for sensors.
Switched supply of additional sensors.
possibility to activate alarm without certain sensors beeing active.
built-in ultrasonic motion detector (optional).
valet (service) mode option.
trunk release button logic.
memory of alarm triggering for 5 cases.
state of system is saved also, if power is suddenly cut.
signalization, if alarm was in nonstandard state.
signalization of door open, trunk, bonnet by activating of alarm.
function ignition safety lock.
function passive arming.
function of reactivation.
option to activate function IMMOBILIZER.
detection of alarm state from original alarm ( in certain vehicles).
direct command of lights trough CANBUS ( in certain vehicles).
programming and updates of firmware
trough USB.
optional control of central locking with RF Module.
optional remote control with RF Module.
optional signalization of reverse gear
Alarm functions
1. ARMING AND CLOSING DOOR LOCKING SYSTEM
Press the button
on the OEM remote
– light will blink confirms the vehicle security system arming and the central
door locking will close. The LED will light constantly and after 10 seconds it will start to blink slowly.
2. ARMING WITH INTERIOR MOTION DETECTOR AND ADDITIONAL SENSOR DISABLED
If the ALARM is armed with any person or animal in the vehicle, their movement will trigger the alarm.
To avoid such situation, the system can be armed without interior motion detector and additional sensors.
To do so, before arming the system - press and hold the valet switch (until the LED starts to blink rapidly).
Exit the vehicle, close all doors and press the button
of the remote - two siren chirps confirm arming without
interior motion detector and additional sensor.
The light will blink to confirm the vehicle security system arming and the central door locking is closed.
The LED will light constantly and after 10 seconds it will start to blink slowly.
3. DISARMING AND OPENING THE CENTRAL DOOR LOCKING SYSTEM
Press the button
of the remote
– the light will blink confirming - disarming of ALARM, central door locking system
will be open.
The status LED will start blinking until any door is opened and then will go off.
If the alarm was triggered during the driver’s absence, the ALARM signalizes it with three siren chirps.
The siren will chirps 3 times, if no input will be activated (trunk, bonnet ...), before doors opening.
If the doors will not be opened until 30
second’s, alarm will activate automatically. See chapter 6.
4. TRUNK RELEASE BUTTON LOGIC
It´s possible to command opening of trunk by button
( if the button is on original remote )
After pressing button will open the trunk. Additional
sensor’s, ultrasonic sensor’s and detection of input of trunk will go
of. During trunk opening LED will be blinking quickly. After closing of trunk the alarm will get again in active state
– all
inputs will be active.
IMPORTANT! This feature is car depended and can work differently in some cars.
www.eldibg.com
car audio & multimedia system
