TSI Instruments PANDA PAN200 Series, Руководство по эксплуатации и обслуживанию

Страница: 12 / 37

8 Chapter 2
a. For positive pressure,
high-flow testing,
remove the low flow
nozzle if it is installed.
Then, connect the grey
cast-aluminum cam
lock connector to the
outlet side of the
blower per Figure
6
.
Close both cam lock
arms at the same time
to ensure proper fit.
Connect the free end of
the 16-ft (5-m) silicone
Figure 6. Positive Pressure,
High-Flow Set-Up
tube to the pressure tap marked
DUCT PRESSURE P3 (+)
on
the black square box.
Finally, verify that the
FLOW GRID MODE
pressure taps on
the inlet tubes are connected to the
FLOW GRID
pressure
taps, i.e.,
P1 (+)
to
P1 (+)
and
P2 (-)
to
P2 (-)
.
b. For positive pressure,
low-flow testing, add
the low-flow nozzle to
the blower inlet if it is
not installed per
Figure 7. Then, connect
the grey cast-aluminum
cam lock connector to
the outlet side of the
blower per Figure
6
.
Close both cam lock
arms at the same time
to ensure proper fit.
Figure 7. Positive Pressure,
Low-Flow Set-Up
Connect the free end of the 16-ft (5-m) silicone tube to the
pressure tap marked
DUCT PRESSURE P3 (+)
on the black
square box.
Fan
Outlet
Cam Lock
Connector
Low Flow
Nozzle
Fan Inlet
www.netzerotools.com
www.netzerotools.com