TSI Instruments PANDA PAN200 Series, Руководство по эксплуатации и обслуживанию

Страница: 19 / 37

Performing a Duct Leakage Test 15
Instrument Operation if SMACNA Test Protocol is Selected
1. Enter key parameters:
a.
Surface Area of ductwork
section to be tested.
b. Static Pressure of test, as
measured by Model 5825
micromanometer.
c. Flow Device as Nozzle or
Flow Grid.
d. Leakage class as a number
from 1 to 48. Typical values
are 3, 6, 12, 24, or 48.
e. Test Length, or duration of
leakage test.
2. Increase the blower speed
until the desired static pressure
is achieved.
3. When the static pressure has
stabilized, select
Run Test
and
press .
4. The display will show the
readings on the right. Leakage
LEAKAGE TEST
Surface Area
Static Pressure
Flow Device
Leakage Class
Test Length
Run Test
LEAKAGE TEST
Leakage Factor x.xx
Leak Limit x.xx
Leak Rate x.xx
Status OK
Flow Device Flow Grid
Baro Pressure 20.20
Temperature 20  C
Time 9:55
Standard TestXXX
Sample
0
(Sample Saved 1)
Stop(Save) Print
Factor and Leak Rate will update in real time, while other
parameters will remain constant.
If the Leak Factor and Leak Rate are sufficiently stable, press the
START
soft key or the key to begin the leak test. Pressing the
ESC
key will exit back to the previous screen.
5. After the leak test is complete, the Model 9565-P will prompt you
to press the
SAVE
or
PRINT
soft key. You can also press the
ESC
key here to back out to the previous screen without saving
the data.
After completing leakage testing for a section of duct, you can move
on to the next section.
www.netzerotools.com
www.netzerotools.com