TSI Incorporated DUSTTRAK DRX 8533, Руководство по эксплуатации и обслуживанию

Страница: 24 / 85

Chapter 2 14
Notes
1. The power connector and the flow quick connect
“click” when
securely connected. The power connector must be rotated
clockwise past the locking pin.
2. Do not hot-plug the External Pump Module when the
DustTrak monitor is turned ON. Always connect the External
Pump module first and then turn the DustTrak monitor ON.
3. TSI recommends that the DustTrak monitor with the external
pump be operated in the Model 8535 Environmental
Enclosure.
4. TSI recommends that the pump module be operated when
mounted on its feet and avoid operating at other orientations
as much as possible.
5. Pump module and the DustTrak monitor should be at the
same electrical potential.
6. The additional port on the external pump module is where the
pump exhausts the flow. For applications where the DustTrak
monitor is sampling from a chamber or a duct at pressures
significantly different from the ambient, TSI recommends
plumbing the exhaust of the external pump back in to the
chamber/duct.
Using the AC Adapter to Run Instrument
The AC adapter allows you to power the DustTrak monitor from an AC wall
outlet. When using the AC adapter, the batteries (if installed) are bypassed.
Battery Charging
This instrument will charge the Lithium Ion battery packs. Insert the batteries
into the battery compartment, plug the instrument into AC power, and turn the
instrument on. Batteries will charge only when the instrument is on and in
stand-by mode. Batteries will not charge if the instrument is turned off or is
actively taken measurements. Charging will stop when the batteries are fully
charged.
W A R N I N G
When Charging Battery the ambient temp must not
exceed 42°C.
Inlet Cap
When using the DustTrak monitor to sample environmental air, the inlet cap
should be put over the instrument. This cap will keep large objects from
dropping into and plugging the inlet. The cap will also keep direct light from
shinning into the chamber and skewing the results.
The inlet cap can simply be pressed onto the instruments inlet.