TSI Incorporated 8372, Руководство по эксплуатации и обслуживанию

Страница: 42 / 55

32 Chapter 2
set to the same baud rate as the A
CCU
B
ALANCE
Plus. To change the baud
rate of the printer, please refer to that operation and service manual. Always
turn the
A
CCU
B
ALANCE
Plus on before the printer. If the printer prints
question marks (??????), asterisks (******), or random characters, reset it
by turning it off and then on again. If necessary, refer to the
Model 8925
Portable Printer Operation and Service Manual.
When viewing statistics, the statistic shown on the display for the current
Test ID will be printed automatically when the
STATISTICS
key is pressed.
When reviewing data, nothing will print. When taking a sample, the reading
will be printed automatically each time the
SAMPLE
key is pressed. Figures
16 and 17 depict the printout of each unit. Note that on the printout for
Model 8373, the symbol “^” is used. This indicates that the flow is
RETURN flow.
Figures 16& 17: Samples of Data Printed Out on Optional Printer
Press the Left Handle Button to print the displayed reading to the printer.
The A
CCU
B
ALANCE
Plus allows printing of the entire memory or only the
data stored within a particular Test ID. To print data from memory, press
and hold the Left Handle Button. This will initiate a countdown from 5 to 0
on the small display with
“PRNT”
on the large display. When the small
display shows “0”, release the button. If you release the key at any time
other than 0 during the countdown, nothing will print. After the small
display shows 0, the small display will then show the word
“ALL”.
To send
all of the data that is in memory to the printer, press
ENTER
. To select a
specific Test ID to print, before pressing the
ENTER
key, use the
▲
or
▼
key
to select the desired Test ID, then press
ENTER
. The display will read “Send
dAtA” while sending the desired information from the instrument memory.
To stop printing at any time, turn the A
CCU
B
ALANCE
Plus off. NOTE: In
order to print, the baud rate on the A
CCU
B
ALANCE
Plus must be set to the
same baud rate as the printer (default is 1200).
ACCUBALANCE MODEL 8372
SERIAL NUMBER 12345678
STANDARD
Kfactor = 1.00
TC = 1 SEC
12/01/98
14:01:40 940 l/s SUPPLY
14:01:49 940 l/s RETURN ACCUBALANCE MODEL 8373
SERIAL NUMBER 12345678
STANDARD
Kfactor = 1.00
TC = 1 SEC
12/01/98
14:01:40 940 l/s 25.7
°
C
14:01:49 940^l/s 25.7
°
C