TN-M series crane scale technical manual
- 3 -
3. INSTALLATION
3.1 Unpacking
When you receive the scale, inspect it to make sure that it is not damaged and that all
are parts are included:
Remove the scale from the carton.
Remove the protective covering. Store the packaging and to use if you need to
transport the scale later.
Inspect the scale for damage.
Make sure all components are included.
Crane Scale 2.Remote control 3. Adaptor 4. Manual
3.2 Installation
The location must be such that the instrument is not subject to excessive vibrations,
heat or humidity.
Avoid direct sunlight on the front of the instrument.
The unit has to be installed at the right height to allow an easy reading of the display
and convenient keyboard operation.
The loads which hang on the hook should be a vertical load.
3.3 Power Connection
Connect the adaptor pin in to the indicator adaptor jack.
Adaptor jack is locating below the scale.
Adaptor connects into your AC power socket. Plugable
equipment must be installed near an easily accessible
socket outlet with a protective ground/ earth contact.
3.4 Rechargeable battery operation
Note: Please charge the battery before using the scale for the first time
.
The [
] indicator above
indicator appears indicates that the battery is getting
low. It
’
s time to charge the battery with the AC power. If scale goes on being used
without proper charging, <LO-BAT> words will flicker on the display.
Approximately 30 minutes of instrument usage are left; afterwards it will shut off
automatically.
Please use the supplied battery charger for charging the battery immediately,or scale
cannot be used.
3.4.1 Charging the battery
Before the first use, the battery should be charged by connecting it to the mains
power supply for at least 5 hours.
Adapter jack
