TN-M series crane scale technical manual
- 17 -
6. PARAMETERS
6.1 PARAMETER SETTING
Enter the Menu
Turn on the scale.
Press
TARE
key during that start up until display will be shown P1---;
Then input password,the default password is 000;
Press
G/N
key to move the active digit;
Press
TARE
key to increment a digit;
Press
ZERO
key to confirm, display will shows
“
F0 cal
”
, scale enter setting mode
Enter the Selected Menu
Press
ZERO
key , it can confirm which will be shown displayed.
Select the Menu
Press
TARE
key, it can choose menu block one by one.
Escape from the Menu
Press
G/N
key to escape from the setting menu.
To access the technical parameters,it
’
s required to press the calibration switch, switch is
locating below the housing.
