52
button to resume printing.
B. Is there any label stuck on the label sensor? Is there any pre-printed logo on
the label? Please refer to
5.3 Printer Initialization
to reset the system.
If the pre-printed logo or text influences the auto gap calibration function, please
calibrate the gap sensor with proper sensitivity setting by try and error method.
Example:
C:\>COPY CON LPT1 <Enter>
SET GAP 1 <Ctrl> <Z>
Main board, gap sensor or black sensor failure.
If you confirm the main board is good, Please change the gap sensor receiver
first, because the receiver sensor failure rate is higher then the transmitter
sensor.
4.
The printer setting runs error
.
Printer setting runs error:
Refer to
5.3
Initialization
to reset the system.
5.
Continuous feeding labels
The printer setting may go wrong. Please do
“Printer Initialization” and “Gap
and Black Mark Sensor Calibration
”. (Refer to 5.2 and 5.3).
6.
No print on the label
Is the thermal head connector connected?
Is the thermal head broken? Check it by printer self-test printout.
Is main PCB U14, U15, Q1 or Q2 broken?
7.
Printer does not print.
Printed by enclosed BarTender
This may be driver conflict problem. Please remove all the drivers in the
printer folder and then re-install the driver for your printer.
Printed by printer command (other error).
This problem is caused by incorrect syntax commands. This printer will ignore
incorrect syntax commands. Please set the printer to the dump mode and
make sure the printed command is identical to the commands sent from the
application software.
The printer serial port setting is not correspondent to the PC’s setting
Please do the configuration by the following commands.
C:\>COPY CON LPT1 <Enter>
