48
5. GAP AND BLACK MARK SENSOR SELECTION
Both gap sensor and black mark sensor are available in TDP-245 Plus series.
Gap sensor is set as default, so there is no extra setting for gap sensor.
Gap Sensor
Default setting. No extra action necessary.
If you would like to switch back to gap sensor, please initialize the printer.
Black Mark Sensor
Go to MS-DOS prompt mode and enter following command to switch sensor to
black mark sensor.
C:\>COPY CON LPT1 <ENTER>
BLINE
width
,
offset
<CTRL><Z>
ex: BLINE 3 mm, 0
C:\>
Or start the labeling software, set sensor to black mark sensor then print one label.
The sensor will be switched to black mark sensor.
Please calibrate the sensor after sensor selection.
Note:
1. <ENTER> means PC keyboard
“Enter” key.
2. <CTRL><Z> means to hold
“CTRL” key then press “Z” key.
