© Trynex International 2007 L1102
5 — 31
XMT-175 Vee Pro Express Mount Kit
Mounting Instructions
IN BED EXPRESS MOUNT
Step 1:
Locate left and right side mounting rail
and
.
Step 2:
Locate item
cross rails.
Step 3:
Assemble items
,
,
together per exploded view. (Accessory Shim
may be needed for adjustment).
Step 4:
Install rear latches items
and
with 5/8" thin lock nut
.
Step 5:
Place frame assembly on truck and center left to right.
Step 6:
Install items
,
&
per illustration.
Note: on older models, you will have to drill out frame to accept item
stop
bolt. To do this, you will need to bolt item
to lower frame rail using a drill template to locate the bracket, drill all four
holes and then install items
,
&
.
Step 7:
Determine front to back location by either placing spreader into locked position into frame assembly or by measuring using rear
side frame holes and measuring to rear of pick up bed. Mark holes with paint marker or scribe. Verify that there are no critical components
below the pick up bed such as a gas tank, etc.
Step 8:
Drill holes and mount frame using supplied 5/8" hardware.
Note: There are alternate holes for drilling around items that
may be in the way.
WHEEL KIT
Step 1:
Assemble item
to item
using supplied hardware.
Step 2:
Assemble items
to item
using supplied hardware.
Step 3:
With spreader in truck, place item
wheel arm on the rear center of upper rail of hopper (see illustration/pictures).
Step 4:
Place item
on auger weldment and trap the lower edge while at the same time positioning item
to engage item
so that
item
pin with ring can keep the two assemblies together.
Step 5:
Lock swivel wheels.
Step 6:
Pull spreader back and off the in bed mount, allow spreader to rotate towards ground with the locked wheels touching first.
Step 7:
Continue to pull spreader into a vertical position.
Step 8:
When everything is stable, release wheel locks and slowly move spreader to storage location. Lock wheels when final place has
been established.
Step 9:
See photo and drawing illustrations for assembly and installation.
Note: Ratchet straps must still be used as part of the mounting system.
Содержание SnowEx Vee Pro 3000
