Trynex SnowEx Vee Pro 3000, Руководство владельца/оператора

Страница: 36 / 44

L1102 © Trynex International 2007
5 — 36
Operating the Spreader
(continued)
BAFFLE INSTRUCTIONS
• The Vee Pro 3000/6000/8000 uses a single baffle design over the
auger area. This baffle is used for salt/sand mixtures of 50% sand
and 50% salt.
• WARNING: Always disconnect power source before attempting to
remove material baffle.
• The main baffle (D 6577) MUST never be removed from its original
factory installed position unless the unit is being serviced or
installing Optiflow Kit.
WARNING PROTECTION
• If audible beeping occurs, read display to identify problem. If display reads “OL” (overload) or “OH” (overheat). Shut controller down and
carefully clear jammed auger. If display reads “E1“ this means there is a dead short in system. Do not use until problem is corrected. If
display reads “E 0” this means that the motor is not getting any power. Check all connections. If display reads “LB” the vehicle battery
is extremely low and could damage system.
• If there are any problems while operating the spreader, refer to Troubleshooting Guide.
AUTO-REVERSE “AR” FUNCTION
• If your controller displays “OL” this could indicate a jammed auger.
• To engage the Auto-Reverse “AR” function:
Step 1: Shut the Main Power Switch OFF for 3 seconds.
Step 2: Turn the Main Power Switch ON. When the machine starts back up the “AR” sequence will automatically start and the auger
will reverse for several rotations to clear the jam.
• After a pause of several moments, the auger will automatically return to correct rotation.
• If the jam is still not cleared, the controller will again display “OL”.
• You may repeat Steps 1 & 2 for a second and third time.
• If after the third try the controller displays “OL” — you must extract the material that is causing the problem.
• Follow all warning directions when clearing jams.
D6577