Secure Web Gateway 11.5 Setup Guide
Copyright © 2013 Trustwave Holdings, Inc. All rights reserved.
8
2.1.2.2
For an SWG 7000 appliance:
The SWG 7000 model is a chassis containing blade servers, each of which operates as an appliance. This
provides for overall higher end performance.
Perform the following procedure for each blade regardless of its intended network role.
1.
Plug in the power cables.
2.
Configure the network settings of any PC to match those of the appliance (IP address and subnet
mask).
•
IP address in the same subnet e.g. 10.0.0.101
•
Subnet mask 255.255.255.0
3.
Connect your PC to one of the ports on the Gigabit Ethernet switch in I/O switch module Bay 1 on
the appliance using an ethernet cable.
4.
Power up the blades as follows:
In the control panel for the blade:
a.
Press the KVM Select button so that the VGA screen attached to the chassis displays output from
the blade being powered up.
b.
Press the Power button until the blade turns on. After the blade finishes booting, a login prompt
is displayed.
5.
Continue by doing either of the following:
•
Repeat Step 1 for each blade, and when done, continue with initial setup of your SWG Appliance
blades using the Limited Shell, or
•
Continue with initial setup of this SWG Appliance blade using the Limited Shell, and when done,
repeat Step 1 for each blade.
Note:
For more information on setting up the SWG 7000, contact your Trustwave representative.
