Secure Web Gateway 11.5 Setup Guide
Copyright © 2013 Trustwave Holdings, Inc. All rights reserved.
17
disable_service_snmpd
Disables the snmpd network service. Enter the disable_service_snmpd command.
disable_service_ssh
Disables the ssh network service. Enter the disable_service_ssh command.
enable_ ...
Enables the network service. The enable command includes the enable_service_snmpd and
enable_service_ssh commands.
enable_service_snmpd
Enables the snmpd network service. Enter the enable_service_snmpd command.
enable_service_ssh
Enables the ssh network service. Enter the enable_service_ssh command.
ethconf
Enables configuring the Network Interface parameters.
Enter the ethconf command and choose the required interface. Choose the required speed or select Auto-
negotiation to enable the appliance to negotiate its own speed.
Enter the ethconf command and choose the interface, for example, enter 1 (eth1).
The settings for the selected interface are displayed.
Choose configuration for the adapter and confirm to make the settings permanent
Note:
According to the IEEE 802.3 standard, when working with 1000Base-T at a speed of 1000Mbps,
auto-negotiation must be enabled. A fixed speed of 1000Mbps is not supported. For more information,
refer to the 1000BASE-X Auto-Negotiation standard as defined in Clause 37 of the IEEE 802.3 standard.
flush_dnscache
Flushes the dns cache.
reset_config
Rebuilds the appliance configuration in extreme situations where the appliance, for whatever reason, was
disconnected for a period of time. This action restarts the appliances and may take several minutes.
