TRUST 732AV LCD POWER VIDEO
5
U K
2.
Insert the two AA batteries into the camera as shown above the battery
holder.
3.
Close the battery flap by sliding it closed.
4.
The TRUST 732AV LCD POWER VIDEO is now ready for use.
Note:
Only use non-rechargeable alkaline batteries or NiMH 1600 mA, or
higher, rechargeable batteries. Other types of batteries do not work
correctly in this camera.
Note:
Digital cameras use a lot of power. The batteries will last
approximately one hour if the LCD screen is used. They may not last
as long if video is recorded continuously. The life span of the batteries
also depends on the make and type of batteries and the make and
capacity of the CF card. Use Duracell Ultra batteries or rechargeable
NiMH batteries for a longer life span. Turning off the LCD screen will
also make the batteries last longer.
The battery condition is shown on the LCD screen (10, figure 2) as follows.
The batteries are full.
The battery capacity is low. Only a few more photographs can be
taken.
The batteries are empty.
Table 6: Battery conditions
4.4
Turning the camera on and off
See figure 1 on the first page of this instruction manual. The camera does not have
a separate ON/OFF switch. Unfolding the LCD screen will turn on the camera. You
can also turn the camera on using the menu button (9):
1.
Press the menu button and keep it pressed. The LED on the rear of the
camera will be lit.
2.
Wait 5 seconds whilst keeping the button pressed. A noise will be heard. The
camera has now been turned on.
3.
In order to use the LCD screen, check whether the LCD switch (18) is
pointing upwards. The LCD screen is turned off if this switch points
downwards. Turning the LCD screen off will increase the life span of the
batteries.
Turning the camera off
1.
Press the menu button and keep it pressed.
2.
Wait 5 seconds whilst keeping the button pressed. The LCD screen will turn
off. The camera has now been turned off.
Tip:
The camera turns off automatically if it is not used for approximately 1
minute. The display will be turned off when the LCD panel is folded.
4.5 Menu
system
See figure 1. Most settings are available on the LCD screen via the menu. Use the
menu as follows.
1.
Turn the camera on (see chapter 4.4).
2.
Press the menu button for a short period. The menu will be displayed. A short
description of the symbols is given in figure 2 and table 5a and 5b.
3.
Push the menu button downwards to move down items and push the menu
button upwards to move up items.