1
2
1
2
6
• Before adjusting the height of cut, turn
off and disconnect the router from the power source.
• Rest the router base on a flat, level surface with the front
of the router facing you.
• Open the lever (
F
) on the stationary base.
• With the cutter bit already installed, push down on the
cylinder until the bit is very close to the surface on which
the outer is resting (
1
).
• Turn the fine height adjustment knob (
G
) until the drill
bit barely touches the surface on which the router is
resting. This point should be considered as 0 penetration.
• Place the router on two pieces of scrap work that are
level and position it so that the drill bit can be lowered
underneath the base of the router (
2
).
• Rotate the fine height adjustment knob (
G
) to lower the
drill bit to the desired depth of cut. Turn in the opposite
direction to raise the bit.
• Once you determine the depth of cut, close the lever (
F
)
on the fixed base.
Cutting height adjustment
9
Start up
F
A
G
• Connect the router to the power source.
• Use the switch (
A
) to turn the router motor on or off. To
turn on press the switch to the "O" mark, to turn off press
the switch to the "I" mark.
• When turning the motor on, wait until
the drill bit reaches full speed to make contact with the
workpiece.
• When turning the motor off, wait for
the drill bit to come to a complete stop before removing
the drill bit from the workpiece.
• The motor is configured to minimize torque by limiting
its speed during start-up, which increases its life.
• The motor features electronic feedback control that
maintains constant speed under load to provide proper
control and ensure a smooth finish.
Start-up and operation control
ENGLISH
CAUTION
CAUTION
CAUTION
