7
Set up
• Before installing or removing a drill bit,
turn off and disconnect the router from the power source.
You can perform drill bit installation and demounting in two
ways:
1. By removing the cylinder.
• Remove the cylinder (
A
) from the fixed base as described
in the previous section and rest the motor head on a flat
surface with the cylinder pointing up.
• Depress the shaft lock (
G
) to prevent the shaft from
rotating.
• Without releasing the shaft lock, loosen the collar nut (
H
)
with the 7/8” wrench (
I
).
• Place the drill bit (
J
) in the collet, the shank must enter at
least 19/32" to ensure that the drill bit does not accidentally
come out.
• Tighten the collet nut firmly with the wrench to secure the
drill bit.
• Release the spindle lock (
G
) and make sure that the drill
bit is securely in place.
• To remove the drill bit, depress the spindle lock and
loosen the collet nut with the wrench provided.
2. Without removing the cylinder.
• Remove the drill bit as explained in the previous section.
• Use the 1/2” wrench (
K
) to secure the shaft to prevent it
from turning.
• Hold the collar (
H
) with the 7/8” wrench (
I
) and turn the
nut counterclockwise.
• Place the 7/8” wrench on the collar and the 1/2” wrench
on the motor shaft.
• Hold the 1/2” wrench and loosen with the 7/8” wrench.
• Place the drill bit in the collet the shank must go in at least
19/32" to ensure that the drill bit does not accidentally come out.
• Replace the 1/2” wrench and tighten firmly with the 7/8” wrench.
• To remove the bit, follow the reverse of the installation procedure.
Drill bit installation or disassembly
• The router motor is housed in the vertical cylinder (
A
)
which raises or lowers inside the fixed base (
B
) to adjust
the drill bit to the proper height for the work to be
performed.
• Before installing a drill bit or changing
the collet or clamp, the cylinder must be removed from
the fixed base.
• Before disassembling or assembling
the cylinder, turn off and disconnect the router from the
power supply.
• To remove the cylinder, release the lever (
C
) from the
fixed base clamp.
• Lift the motor head (
D
) until the cylinder is removed
from the fixed base.
• To reassemble the cylinder, make sure to align the
toothed groove (
E
) with the base sprocket (
F
).
• Insert the cylinder into the fixed base.
• Push the lever (
C
) to close the clamp.
Disassembly and assembly of the cylinder
J
C
A
E
A
D
F
K
I
I
G
H
H
B
Loosen
Tighten
ENGLISH
CAUTION
CAUTION
CAUTION
