Truper 102272, Руководство пользователя, Страница: 7 / 20

1 2
3 4
Quick adjustment:
• Hold the moving body (
C
) firmly, loosen the bolt (
D
)
and raise or lower the moving body to the desired
position.
• Secure the moving body in position by tightening the bolt
(
D
).
• The moving body can also swing slightly in both
directions to accommodate larger workpieces on the base
plate; however, be careful not to swing too much to keep
the drill shaft within the iron base area.
Depth control:
• The drill stand features a fine depth control ( E ), very
useful for repeating holes of the same depth.
• Turn the depth adjustment knob:
Left greater depth /Right less depth.
• Check the scale ( F ) and depth indicator ( G ) when
pressing on the control lever.
• The mobile body of the tool accepts drills with collars of
43 mm, and collars of 35 mm.
• Insert the drill collar into the clamp of the mobile body
completely as shown in the picture.
• To use drills with 35 mm collars it is necessary to first
place the adapter ( A ) in the clamp.
• Make sure that the drill is completely inserted and in
vertical position inside the clamp and then firmly tighten
the lock (
B
).
7
Preparation
A
F
E
G
D
I
I
H
H
C
B
Height adjustment of the moving body
• The holder must never be used without the workpiece
being properly clamped.
• To adjust the press:
1
. Press button (
H
). Without releasing the button pull the
knob ( I ) outward.
2
. Place the workpiece.
3 . Press the button again and while holding down the
button, push the knob until it touches the workpiece.
4 . Release the button and turn the knob clockwise to
secure the workpiece.
• In addition to the press supplied, the iron base is
designed to accept a variety of clamps that can be secured
with bolts, washers and nuts.
• If the drill bit becomes jammed in an
improperly secured workpiece, injury to the operator may
result.
Walrus press
Drill mounting
WARNING
ENGLISH