Truper 101606, Руководство пользователя

Страница: 7 / 24

7
Start Up
The battery comes DISCHARGED from the factory. You will need to charge it for approximately 1 hour 30 minutes before you can
use it.
The normal charging temperature is 32 °F to 113 °F. Outside this range, charging is automatically suspended until the correct
temperature is reached. The normal discharge / working temperature is 32 °F to 167 °F. If 167 °F s exceeded, the electronic
control shuts off the power to the tool until the temperature reaches the optimum temperature range again. When the
battery is below normal voltage during work, the tool stops working. Between each charge, give the charger 15 minutes rest.
In a hot environment or after prolonged use, the battery may become too hot to be recharged. Allow the battery to cool
before attempting to recharge.
• To install the battery in the tool handle, align the battery unit with the
rails on the inside of the tool handle and slide it into the handle until
the battery unit is firmly inserted into the tool; check that the battery
unit does not slip out by itself.
• To remove the battery unit from the tool, press the release button (
C
)
and pull the battery unit firmly out of the tool handle.
Considerations for battery use
Installing and removing the battery
• To screw in, release the switch and press the direction of rotation
button on the side where the marks point towards the drill bit.
• To reverse direction and unscrew, press it on the opposite side.
• The tool switch locks if the direction of rotation button is in the
middle position.
• The first time you turn on the tool after reversing
the rotation, a click may be heard. This is normal and does not
represent a problem.
• Never reverse the direction of rotation while the
tool is running to avoid damaging the tool.
• The belt clip can be attached to either side of the tool using only the screw provided, to accommodate left or
right-handed users.
• If you will never need the hook, you can remove it from the tool.
• To move the belt clip to the other side, remove the screw holding the belt clip in place and reassemble it on
the other side. Be sure to tighten the screw securely.
Rotation direction
Belt clip
Forward Reverse
Bit installation
Removing the accessory
1. Install the direction knob in the locked position (center).
2. Pull the tip holder collar (
D
) away from the front of the tool.
3. Insert the tip and release the collar.
4. When you hear a click, the accessory will be locked.
1 . Pull the tip holder collar ( D ) away from the front of the
tool.
2 . Remove the accessory from the tip holder.
D
D
C
ENGLISH
CAUTION
CAUTION