Trumpf TruTool S 350, Руководство оператора

Страница: 18 / 24

18
Operation
E464EN_04.DOC
Working with the TruTool S 350
¾
Move the On/Off switch to the front.
1
80°-90°
1 On/Off switch
1. Do not move the machine towards the workpiece until full
speed has been reached.
2. Machine/process the material
–
Move the device forward at an angle of 80 to 90° to the
sheet surface.
Requirements for the cutting of radiuses
•
Do not tilt the machine.
•
Proceed with a low feed rate.
Requirements for cutting near the margin
•
Cut in upside-down position, meaning that the cutting table is
facing upwards.
¾
Move the On/Off switch to the rear.
Switching on the
TruTool S 350
Working with the
TruTool S 350
Fig. 28475
Switching off the
TruTool S 350