Trumpf S 160 - 7, Руководство оператора

Страница: 3 / 8

E241en1_2.doc S 160 - 7
GB
1
Hand sheers S160-7 Fig. 10232
S 160-7 specifications
Max. material thickness:
•
Steel up to 400 N/mm
2
1.6 mm
•
Steel up to 600 N/mm
2
1.2 mm
•
Steel up to 800 N/mm
2
1.0 mm
•
Aluminium 250 N/mm
2
2.0 mm
Smallest radius for
curve-shaped cutouts
15 mm
Working speed 5-7 m/min
Nominal power consumption 520W
Number of strokes
under maximum load
max. 3000/min
Weight 1.5kg
Operating pressure (flow pressure) 6 bar
Air consumption at 6 bar 0.4 m
3
/min
Required inner
∅
of compressed air tube 9 mm
(maximum output is not reached if
∅
is smaller)
Noise / Vibration
Measured values established in acc. with EN 50 144.
The A-weighted sound level of the unit is typically 73
dB (A). The noise level can exceed 85 dB (A) during
operation.
Wear ear protection!
The weighted acceleration is typically 2.60 m/s
2
.
Proper use
The TRUMPF hand sheers S160-7 are a pneumatic
hand machine
•
used to part plate-shaped workpieces made of
material such as aluminium, plastic, etc.
•
to cut straight or curved outer edges and inside
cutouts
•
to cut along a scribed line
Safety instructions
The machine can only be operated safely if
you have read and understood both the
operating and safety instructions (red print)
and follow these instructions carefully.
The unit may only be used with a chip
deflector (hand protection).
Check the unit, compressed-air tube and reception
coupling before each use.
Have all damaged parts repaired by an expert.
Always wear safety glasses, ear
protection, protective gloves and
proper footwear when working with the
machine.
•
Do not connect the compressed air unless the
machine is turned off.
•
Always disconnect the compressed-air tube from
the machine before beginning any work on the
machine!
GB
9 Ram
11 Top cutter and bottom
cutter
12 Fastening screw
14 Fastening screw
15 Adjusting screw
16 Fixed blade carrier
18 Chip deflector
(Hand guard)
324 Lever and On/off switch
331 Sleeve
9
12
11
11
14
15
16
18
324
331