Trumpf S 160 - 7, Руководство оператора

Страница: 4 / 8

2
GB
S 160 - 7 E241en1_2.doc
•
Always guide the compressed-air tube back away
from the unit.
•
Use only original TRUMPF accessories.
Before initial use
1. Read the chapter on safety
Safety instructions
2. Check whether the installed cutters are suitable
for the material that is to be machined. For
high-tensile sheets (> 400 N/mm²) special
cutters should be used!
Cutter selection
3. Turn or replace blunt cutters.
Cutters
4. Check whether the cutting clearance is suitable
for the sheet thickness that is to be machined.
Cutting clearance
5. The flow pressure of the compressed air must
be 6 bar at the point of extraction.
6. Oil lubrication must take place for the
compressed-air motor
Maintenance
Operating instructions
Check the tools for wear and the oil lubrication of the
compressed-air motor every hour.
Never work with blunt tools!
(the compressed-air motor may stop).
Turning the unit on and off
Fig. 10217
Turning on the unit : Press lever 1.
Turning off the unit: Release lever 1 (the lever
springs back into intial position and the flow of
compressed air is interrupted).
Do not begin machining the workpiece
until after the machine has been turned
on and has reached maximum speed!
Guide the unit towards the sheet surface at an angle
of 80° to 90° (figure).
Fig. 10263
Do not overload the unit and cause it to stop.
1
1 Lever