Truma Powrtouch Freedom RV, Инструкция по эксплуатации

Страница: 4 / 24

Issue 1 – January 2020 Page 2
•
The 12volt leisure battery MUST be fully charged and in good condition to enable the
Powrtouch Freedom to operate to its full performance specification
– to check your
battery see Section 5 Paragraph 5.4 of this instruction manual.
•
The handset is powered by a 9volt DC battery (MN1604A or 6LR61).
•
The wiring and cabling supplied by Truma for the installation of the Powrtouch Freedom
are to the correct voltage and current rating, under NO circumstance should any other
wiring or cabling be used unless supplied by Truma or written approval is given for their
use. If cutting motor cables (not recommended) these should be kept of equal length, no
cable joining system should be used to lengthen them.
•
When the Powrtouch Freedom is switched on and/or in use there will be 12volts at the
two battery terminals on the Electronics Control Box (ECB). Under no circumstance
should any metal object be allowed to touch these terminals.
•
The Powrtouch Freedom is not a RV jacking point and should never be used as such.
•
The Powrtouch Freedom is not a brake or braking system and should never be used as
such. When stopped always apply the RV handbrake and remove the rollers from the
tires.
•
Be aware that the Powrtouch Freedom adds weight to the RV and the corresponding
weight of your mover must be considered when calculating your payload.
•
Never allow children or persons unfamiliar with the use of the Powrtouch Freedom to
operate the unit.
•
When operating the Powrtouch Freedom, please ensure that no object (e.g. Body parts,
clothing, hair or any other objects carried on the body) can become trapped by any
moving parts of the mover (e.g. rollers).
FCC warning statement :
•
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference
that may cause undesired operation.
•
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating
instructions for satisfying RF exposure compliance. This transmitter must not be
co-located or operating in conjunction with any other antenna or transmitter.
•
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment