Truma Powrtouch Freedom RV, Инструкция по эксплуатации

Страница: 5 / 24

Issue 1 – January 2020 Page 3
SECTION 2
– OPERATION OF YOUR POWRTOUCH FREEDOM
2.1 POWRTOUCH FREEDOM OPERATION:
Carry out the Powrtouch Freedom pre-movement safety checks as Section 1 Paragraph 1.1;
also ensure that the RV is safe to move and that there are no obstructions to prevent the
engagement of the drive rollers to the RV tires.
2.2 SWITCHING ON THE POWRTOUCH FREEDOM
The Powrtouch Freedom control system is switched on by inserting the key into the isolation
switch and then turning the key clockwise, the isolation switch is usually situated in the sealed
area of the RV battery box. When the control board is switched on the unit first initialises, and
then looks/waits for the welcome/coding signal from the handset. The green light should
illuminate on the ECB situated in the RV. (See Section 5 Paragraph 5.3)
ℹ️ When the Powrtouch Freedom is not in use it MUST always be turned off at the Isolation
Switch and the key removed. If left switched on it will stay live for 20 minutes (approx.) before
the ECB will go into a hibernation mode. The ECB can only be reinitialised by the following: -
1) Turning off the isolation switch
2) Remove the key from the switch
3) Wait for a minimum of 20 seconds
4) Then reinsert the isolation switch key and turn on
5) Turn on the handset and use the Powrtouch Freedom
WHEN NOT IN USE ALWAYS SWITCH IT OFF AND REMOVE THE KEY
2.3 SWITCHING ON THE HANDSET
To switch on the handset press both
the ‘On’ buttons (D and F) buttons at the same time.
Release them both when the LED array lights up in the settings indicator window. Once it is
ready to operate then one green LED on the extreme right of the settings indicator window will
remain on. If the top row & bottom row of Red LEDs flash alternating, then this in an indication
that the handset battery voltage is low and the battery should be changed as soon as possible
.