27
Installing the battery isolating switch and
connecting the battery
Install the battery isolating switch at a suitable position (near
the battery) in the positive line between the battery and the
control unit.
Make a Ø 25 mm hole.
Turn the key anticlockwise as far as it will go, and then
remove.
Insert isolating switch into the hole and fix with suitable
screws, depending on undersurface.
Split the positive line from the battery, and attach (crimp)
the cable shoes (not included in set) onto the two bare cable
ends.
Re-insert the key and switch to “OFF”. Screw the cables to
the battery isolating switch with the tubular cable shoes.
–
–
–
–
–
Main supply connection
The device must be connected to the mains power supply
in accordance with the respective valid national installation
regulations.
The 230 V electrical connection must always be made by
an expert (in accordance with VDE 0100, part 721 or
IEC 60364-7-721, for example, in Germany). The information
given here is not intended as instructions for you to carry out.
It is for assisting the expert assigned to carry out the job, act-
ing as auxiliary information when connecting the appliance!
Connect the power cable to the main distributor of the
caravan, motorcaravan or boat. Green / yellow cable to the
protective earth!
Check all connections are tight.
Create the network connection via the female device plug
with the 230 V mains cable.
–
–
