Truma AquaGo AU, Инструкция по эксплуатации и установке

Страница: 13 / 36

13
Maintenance
Repairs must be performed by a certified service technician.
Truma recommends that the appliance be serviced annually
by a certified service technician. Verify proper operation after
servicing.
High temperatures or repair attempts while the gas
supply is turned on may result in scalding injuries!
• Turn OFF the electrical power supply and the gas supply
before starting maintenance and repair work.
• Allow the appliance to cool down.
• Never actuate the pressure relief valve as long as the ap-
pliance is still hot.
Injuries caused by the Easy Drain Lever!
• Never actuate the Easy Drain Lever as long as the appli-
ance is under water pressure and/or is still hot.
Sharp edges can cause cuts and injury!
• Always wear protective gloves to avoid injuries from
sharp edges during maintenance work.
Draining the water and cleaning the water
inlet filter
To keep the appliance fully functional, clean the water
inlet filter at least once a year.
1. Set the control panel to “Off“.
2. Remove the access door (refer to “Removing the access door”
on Page 8.)
3. Switch OFF the appliance at the POWER switch.
4. Open all hot water taps and wait for cold water. This will
ensure that hot water is removed from the appliance before
draining.
5. Turn OFF the water supply or switch OFF the water pump.
6. Leave the hot water tap open in order to depressurise and
vent the water system.
Injuries caused by the Easy Drain Lever!
When the Easy Drain Lever is folded out, it protrudes beyond
the side wall of the vehicle.
• When walking past or bending over, make sure that you
and others have sufficient distance.
7. Open the latch with your thumb while pulling the Easy Drain
Lever down as far as it will go.
8. Remove the water inlet filter (or heating cartridge) as shown
in Fig. 10 and clean it with clean water.
9. Inspect the O-rings on the water inlet filter (or heating car-
tridge) for cracks. Change the filter assembly (see, “APPEN-
DIX C – Spare Parts (all models)” on Page 31) if there are
cracks.
I
II
Easy Drain Lever
Water inlet filter *
Water inlet filter *
Top
Latch
Latch
O-rings
* or heating cartridge
Fig. 10