Truma AquaGo AU, Инструкция по эксплуатации и установке

Страница: 10 / 36

10
Operating modes (control panel)
A control panel to select the operating mode is included with
the delivery.
LED 3
Rotary switch
Off
Eco
Clean
Fig. 9
With the rotary switch (Fig. 9) you can choose between the
following operating modes:
Sign Operating mode / Description
ECO
The appliance is now running in energy-saving mode.
• Water temperature at outlet is approximately 49 °C.
• Prevention of freezing by using propane gas. The
temperature in the appliance is automatically
kept above 5 °C.
• During operation, the yellow status LED 3 is lit.
COMFORT
The appliance is now running in a mode that pro-
vides rapid availability of hot water.
• Water temperature at outlet is approximately 49 °C.
• Standby heat.
The temperature in the appliance is automatically
kept above 39 ºC.
• During operation, the yellow status LED 3 is lit.
Off
Stand-by. The appliance is not running in any oper-
ating mode.
• The yellow status LED 3 is off.
To switch off the POWER and gas supply refer
to “Switching OFF the appliance” on Page 10.
ANTIFREEZE
Prevention of freezing using 12 VDC electricity:
Operating mode with installed electric anti-
freeze kit (available as an accessory) and ap-
pliance switched on. The temperature in the appli-
ance is automatically kept above 5 °C.
• During operation, the yellow status LED 3 is lit.
Clean DECALCIFICATION
See “Decalcification” on Page 14.
For safety reasons, after 30 seconds the de-
calcification process cannot be stopped until
the system has been rinsed in accordance with the
instructions. See “Interrupting decalcification” on
Page 16
Description of the yellow status LED 3
(see Fig. 9 – LED 3)
Signal Meaning
LED 3 lit – Appliance is switched on
LED 3 is off – Appliance is switched off.
– See “Troubleshooting” on Page 17.
Every 7 s, LED 3 is
interrupted for 1 s
– The appliance must be decalcified
LED 3 flashes slowly
1 s on, 1 s off
– Decalcification mode has been
activated
LED 3 flashes
quickly
– Before you use the water system
you must rinse it (see step f) “Rins-
ing the water system” on Page 15).
LED 3 flashes
2 x briefly after a
break.
– There is a fault in the appliance.
The exact fault diagnosis must be
determined via error LED 2. Refer
to “APPENDIX A – Error Codes” on
Page 27.
– Risk of freezing, the temperature in
the appliance is below 3 °C.
Switching OFF the appliance
1. Set the control panel to “Off”.
2. Open the access door (refer to “Opening the access door”
on Page 8).
3. Switch off the appliance at the POWER switch (Fig. 8).
The green Power-ON LED 1 (Fig. 8) extinguishes.
4. Close the access door (refer to “Closing the access door”
on Page 8).
5. If the appliance is not needed, turn off the gas supply to the
appliance.
If you intend to put the RV into storage or turn off
the appliance during freezing temperatures, refer to
“Winterising” on Page 11.