TruGolf E6 Interactive Sports Camera, Руководство пользователя

Страница: 3 / 11

2 3
INSTALLING THE
E6 INTERACTIVE SPORTS
CAMERA
If you have a Vista simulator with an overhead light track, continue on to the
next section. Otherwise, go to the “
FOR ALL OTHER SIMULATOR SETUPS
”
section on page 3. There, you can determine the best way to install the E6 ISC,
based on the height of your ceiling and size of your space. Once you determine
this, please view the corresponding video(s), using the link(s) below.
Before starting, here are some terms to get familiar with:
• Play Area: The section of floor where you run toward the ball
• Tee Position: The spot where you place a ball to be kicked/hit
• Floor Area: The section of floor between the Play Area and the screen
INSTALLING THE E6 INTERACTIVE SPORTS
CAMERA ENCLOSURE
The E6 Interactive Sports Camera enclosure should be installed to a height of
8–10 ft. above the floor. If you have a Vista simulator with an overhead light
track, the enclosure can be mounted to the light track. If not, you will need to
attach a light track or a universal projector mount to the ceiling, depending
on the height of the ceiling. See below for instructions.
IF YOU HAVE A VISTA SIMULATOR :
The E6 Interactive Sports Camera enclosure attaches to the light track above
the play area.
THINGS YOU WILL NEED:
• Phillips screwdriver or drill
• Ladder
MOUNTING INSTRUCTIONS:
1|
WARNING! To avoid electric shock, unplug the light track from the power
outlet before attempting any of the following.
2|
If you have a light already installed on the light track, this will need to be
removed first. Simply twist the light 90 degrees and slide it back.
3|
Use a Phillips screwdriver to remove the cap from the end of the light
track and slide the light out.
4|
Slide the E6 ISC enclosure into the light track using the two track guides
on top of the enclosure. The track guides fit only one way, so you may
need to adjust them. Slide the enclosure all the way to end of the track.
(see illustration for final position) .
IMPORTANT! Make sure the end where the cables come out is facing the screen.
5|
If you removed a light in the previous steps, replace it now by sliding it back
onto the track and twisting 90 degrees to lock it in place.
6|
Replace the light track cap.
7|
Plug the power back in and adjust the overhead light to shine over the
back two rows of the TruTrack 2 Club Sensors.
8|
Plug in the USB extension cable’s female end to the camera USB, then
plug the USB extension cable’s male end into an open USB 3.0 port on
the computer.
9|
Plug in the power cable and run both the power cable and USB Cable
along the framing and to the computer (see illustration) .
NOTE: Handle the USB 3.0 Fiberoptic Cable with care as a bend or kink in the
cable will cause a signal degradation or complete loss of signal.
10|
Position the light fixture to shine on the 3 rows of sensors.
IMPORTANT! The overhead light must be positioned to light the 3 rows of
sensors for tracking to work properly when playing golf.