9
Maintenance
Maintenance
General cleanliness will extend the life of the ToteTilter and its mechanical components . Where possible, the
area should be kept free of spills and loose debris .
Monthly Checklist
•Check airlines for cracks and leaks .
•Check actuators for cracks, leaks, or signs of dry rot .
•Check for loose thread connections .
•Grease pivot points .
If any issues are found during the monthly check, cease use of the ToteTilter until they are resolved .
Replacing Airlines
1 . Confirm that the ToteTilter is in the 0° tilt position then disconnect the inbound airline at the pressure regu-
lator .
2 . Remove a leaking airline by pressing the outer ring of the ¼” pneumatic fitting and pulling the airline
outward .
3 . Repeat the same procedure for the other end of the airline .
4 . Use cracked or leaking airline as a guide for the length of the new airline .
5 . Trim new section of airline to the appropriate length .
6 . Install airlines by pressing each end into ¼” pneumatic fittings .
Note:
Give each end a slight pull to ensure the airlines are secured in place .
WARNING
Before maintenance is began remove the inbound air supply from the pressure
regulator . The ToteTilter should be in the 0° tilt position prior to maintenance .
