7
Installation
Fixed ToteTilter
It is advised not to affix the ToteTilter to the floor . If the ToteTilter is affixed to the floor, a potential entrap-
ment area may be formed that is not easily cleaned .
1 . Place the ToteTilter on a level surface, leaving sufficient room for forklift travel .
Note:
Shims, grout, etc . can be used to level the ToteTilter .
2 . The ToteTilter can be set into place using a forklift or other equipment-moving machine .
3 . Mounting holes may have been requested at the time of purchase or may be drilled by the owner in the
available space of the ToteTilter’s stationary base .
• Care should be taken when drilling holes in the stationary base to avoid damaging additional compo-
nents .
• The owner is responsible for determining the most appropriate fastener to be used when mounting a
ToteTilter .
• At no point should holes be drilled or modifications made to the articulating frame of ToteTilter as it is a
structural member . Altering the frame in any way can result in personal injury or death .
• It is not necessary to affix the ToteTilter to a permanent structure, assuming it is operated properly .
4 . Connect the plant-provided airline to the ¼” NPT connection on the regulator (150 psig maximum inlet
pressure) .
Note:
The pressure regulator should be verified at the stated pressure for the specific unit . This informa-
tion can be found on the equipment tag .
WARNING
Operating ToteTilter with pressure regulator in excess of 30 psi can result in un-
safe conditions .
Care should be taken when loading and unloading ToteTilter to prevent
the unit from sliding out .
CAUTION
WARNING
Never attempt to move the ToteTilter or ToteStand with a tote, intermediate bulk
container, or other container placed on top .
Pneumatic connections should be made in accordance with local, state, and
federal codes and standards .
CAUTION
