............ www.truemfg.com ............
True Food Service Equipment, Inc.
5
5
INSTALLATION / OPERATION INSTRUCTIONS
TOOLS REQUIRED:
• Phillips screw driver
•
3
/
8
” (9.5 mm) socket or
3
/
8
” (9.5 mm) wrench
A.
Use a Phillip
s screw diver and remove four screws
from the L-bracket connected the unit to the wood
skid (image 1). Then use a 3/8” (9.5 mm) socket
or wrench and remove the L-bracket from the unit
(image 2).
To avoid damage to glass DO NOT lay cabinet
on its side or back when removing skid,
installing leg levelers, cleaning, etc.
B.
Lift up from the base and walk unit off the skid and
set in final location.
C.
Unblock doors, free plastic wedges, blue foam and
tape. Remove fiberglass tape securing glass.
Remove components: (shelves, brackets, etc.) from
inside cabinet.
WARNING
For proper performance of refrigerated cabinet an ambient
temperature no greater than 75°F (24°C) with a relative
humidity of 55% is required.
LOCATING
A.
Set unit in its final location. Be sure there is adequate
ventilation in your room. Under extreme heat
conditions, (100°F+, 38°C+), you may want to install
an exhaust fan.
WARNING
Warranty is void if ventilation is insufficient.
B.
Proper leveling of your TRUE unit is critical to
operating success (for non-mobile models). Effective
condensate removal and door operation will be
effected by leveling.
WARNING
Display case must be leveled accurately to ensure front
glass door seals properly.
C.
The unit should be leveled front to back and side to
side with a level. Place the level in the interior floor
of the unit and check all four sides.
D.
If the cabinet is not level adjust leg levelers by first
relieving weight to leveler and adjusting by either
hand or wrench. Repeat with all leg levelers until
cabinet is level in all directions.
E.
Ensure that the drain hose or hoses are positioned in
the pan.
F
.
Models with power cord: Free plug and cord from
inside the lower rear of the cooler (do not plug in).
G.
Models with power cord: The unit should be placed
close enough to the electrical supply so that extension
cords are never used.
WARNING
Cabinet warranties are void if OEM power cord is tampered
with. TRUE will not warranty any units that are connected to
an extension cord.
LEVELING
Removing bracket
from skid.
Removing bracket from cabinet.
1
2
