____________________
Note
_____________________
If the switch is operational, you must place the switch off line
before rebooting or you will lose any transmission in progress.
8.
Press the down button until the Reboot submenu item is displayed:
Operation Menu:
Reboot
9.
Press the Enter button. You are allowed to change your mind and not
reboot:
Reboot
Accept?
Yes
No
10. Use the Tab/Esc button to select
Yes
to reboot the switch. Press the
Enter button to reboot the switch and execute the POST tests.
See the switch documentation for information on other switch configuration
settings.
4.1.2.3 Setting the DS-DSGGB-AA Ethernet IP Address and Subnet Mask from a
PC or Terminal
For the DS-DSGGB-AA switch, which does not have a front panel, you
must use a connection to a PC or terminal to set the Ethernet IP address
and subnet mask.
To set the Ethernet IP address and subnet mask for the DS-DSGGB-AA
switch, follow these steps:
1.
Connect the switch serial port to a terminal or PC COM port with a
standard serial cable with a DB9 connector. The serial port is only
used for initial power-on self-test (POST) verification, IP address
configuration, or for resetting factory/default settings.
2.
If you are using a PC, start a remote communication program, for
example, HyperTerminal.
3.
Set the port settings to 9600 bits per second, 8 bits per character, and no
parity.
4.
Turn on power to the switch. The switch automatically connects to the
host and logs in as
admin
.
5.
Enter the Telnet command
ipAddrSet
. Enter the IP address, subnet
mask, and gateway address (if necessary). For example:
admin>
ipAddrSet
Ethernet IP Address [10.77.77.77]:
16.142.72.54
Ethernet Subnetmask [255.255.255.0]:
Return
4–6 Installing Fibre Channel Hardware and Configuring the emx Driver
