Tru-Turf RB48-11A Golf Green Roller, Оригинальное руководство пользователя

Страница: 14 / 56



Maintenance
Transmission (pump, Eaton 11)
• Initially, change the oil at 50 hours running time, then;
• Change oil every 500 hours or annually, whichever
occurs fi rst.
• Change hydraulic oil fi lter every 500 hours or annually,
whichever occurs fi rst.
• Only use the manufacturer’s recommended
replacement oil fi lter .
• When fi tting the fi lter, follow the instructions supplied
with the fi lter. This will ensure that the fi lter remains
tight and that no leaks occur.
• Check all hard line oil pipes for rubbing, excessive
vibration, leaks and tightness on a regular basis.
• Check transmission oil level on oil tank sight glass. Oil
level should remain at a minimum of 25mm (1”) and at
a maximum of 40mm (1.5”) from the top of the tank.
• Oil Capacity including fi lter is 6 liters or 5.3 U.S. quarts.
For the ultimate performance we use and recommend
the Penrite synthetic 5 SAE 5W-60 transmission oil.
(Part No. R5226)
Storing
• It is important to store this roller in the towing
position. This ensures the trailer strut is in the closed
position, protecting the shaft from corrosion, then
failure and also the weight is taken off the roller
bearings.
Service of the drive chain system
• Replacement - Some chains look a like, but they are
not, use only the chain and sprockets recommended
as per the correct spare parts number. Wrong pitch
drive chain fi tted will cause excessive sprocket wear
and possible drive failure.
• Tensioning the drive chain - No adjustment is required;
the chain tension is automatically adjusted.
Lubrication
• Lubricate drive chain with a chain lube such as
Molykote, Innox or ChunkaRocol ITW. Spray on the
inside of the chain so that the lubricant is forced into
each roller and around each pin prior to rolling of the
Greens.
Service of smoothing roller bearings
• Whilst the Roller is suspended by the Trailer, check
operational smoothness of the bearings fi tted to each
smoothing roller by rotating the rollers by hand. If
bearing tightness, roughness or excessive looseness is
detected, replace the faulty bearings.
• If bearings are faulty
(a) Remove the complete smoothing head unit
assembly from the machine, undo the four swivel
mount bolts on the upper body and disconnect the
steering rod, wheel the roller away until the total
head assembly is exposed to work on.
(b) Remove roller shaft bolts from end plates, remove
rollers from the heads.
(c) Fit new bearings, replace rollers into the heads,
lubricate shaft bolts with an anti seize compound
before installing them. Tighten securely and ensure
rollers rotate freely when fully tightened.
or
If the rollers are a sealed type remove the roller and
replace with a complete new roller.
(d) If the connecting rods are removed or lengths
altered ensure they are correctly adjusted so that
the three heads are parallel to each other when in
the straight ahead position. Adjust if necessary