![background image](http://html1.mh-extra.com/html/tru-test/id5000/id5000_service-manual_1173791033.webp)
ID5000, XR5000 Level 1 Service Manual
Issue 4, 8/2017
33
4
Unscrew the four retaining screws holding the PCA to the case front.
Figure 17: PCA retaining
screws
5
Lift and slide the PCA out of the cradle.
Refitting the PCA
The PCA is factory pre-set to ID5000 or XR5000. If fitting a replacement PCA, ensure that the spare part matches
the model being serviced.
1
Fit the PCA in place by sliding the board under the clips and positioning the locating holes over the locating pins on the
cradle.
2
Ensure that the LCD FPC is correctly positioned between the PCA and cradle so that it can be re-connected to its connector
on top of the PCA.
3
Screw in the four retaining screws to fasten the PCA to the case front (see
Figure 17: PCA retaining screws
). If available,
use a torque limited screwdriver set to 0.5 Nm (4 lbf-in).
4
Connect the six FPCs and the battery (see
Figure 16: PCA connections
).
5
Refit the case back (see page 25).
6
Refit the rubber corner bumpers (see page 23).
Replacing the cradle
Removing the cradle
1
Remove the rubber corner bumpers (see page 23).
2
Remove the indicator case
back (see page 25).
3
Remove the battery (see page 28).
4
Remove the PCA (see page 32).
Содержание ID5000
Страница 1: ...Issue 4 8 2017 1 SERVICE MANUAL Level 1...