ID5000, XR5000 Level 1 Service Manual
Issue 4, 8/2017
27
Replacing the case o-ring
1
Remove the rubber corner bumpers (see page 23).
2
Remove the case back (see page 25).
3
Use a fine screwdriver to lever out the o-ring and remove it from the case. Be careful not to damage the mating surfaces of
the case.
4
Do not use a knife to remove the o-ring as it may damage the case; even a small cut can create sealing problems
.
5
Ensure that the seal groove is clean. Use cotton buds (q-tips) or tissues to remove any excess oily residue.
6
Replace the o-ring, taking care to get an even stretch along its length.
Figure 8: Case front assembly
indicating the location of the case
o-ring.
7
Use a plastic pen to ensure that the o-ring sits tightly in the corners.
Figure 9: Using a plastic pen to
press the o-ring into the groove at
the corners.
8
Refit the case back (see page 25).
9
Refit the rubber corner bumpers
(see page 23).
Replacing the battery
The batteries are different, depending on the serial number the indicator has. See
Changes to product
on page 7.
Содержание ID5000
Страница 1: ...Issue 4 8 2017 1 SERVICE MANUAL Level 1...