26
a
b
Ensure that the throttle control is in the correct position. For user safety, it is
important that the throttle works freely when turned to accelerate and check
that it is not blocked. In case you have to do some repair, you have to leave a
distance between the end of the handlebar and 1.5 mm throttle knob.
There are other components that confer the electrical wire, such as: ON / OFF
switch, charging connector, dial adjustment and wiring.
Your
ON-E
is an electric bike, and features a considerable number of electrical compo
-
nents and wiring. All must be protected from water and dirt!
The components are listed below:
Controller:
This electronic element, is the brain of the drive system.
It is powered by the battery and responds to the position of the gas fist. It is turned on
and off by means of a switch On /Off or kill switch.
Engine:
The motor is the end of the line where the power is actually delivered. The
motor is made up of many components. Any servicing must be carried out by trained
technicians only. Please do not attempt to separate or dismantle the motor in any
way.
¡WARNING!
Be careful, the engine increases its temperature with the use of the motorcycle. Do not
touch its surface, it could cause burns.
Battery:
This element contains the energy to move the motorcycle. The battery is 48V.
therefore, a cautious and responsible use is recommended.
Throttle:
This sends an electronic signal to the controller, which is then interpreted to
determinate the power required. The throttle contains a small circuit board that can
be damaged by water. Similarly, the connection between the throttle and controller
must be protected from water at all times. It must be protected from water.
Check the assembly distance between the end of the handlebar and the throttle
control. It must be 1.5 mm to prevent its block with the end of handlebar caps.
12 - ELECTRICAL WIRING
¡CAUTION!
