: 4-cycle .120
15
"
X7
Spinner nut
6
(with 9 servos),
6
6
6 channel radio for aiplane is highly recommended for this model.
Warning
Remove the covering with proper
pressure to cut through only the covering itself.Otherwise,
cutting down into the balsa structure may weaken the
model part and cause accident.
The pre-covered film on ARF kits may wrinkle due to
variations of temperature.Smooth out as explained right.
Pre-cover the covering with clean cloth!
Start at low setting. Increase the setting if
necessary.If it is too high,you may damage
the film.
Iow setting
with cover(cloth)
Top view
Position for
right diagram.
ELEVATOR
Side View
25mm
25mm
Top view
Side View
20mm
20mm
RUDDER
Adjustment.
Adjustment.
1.5mm
7
TP Screw (2.3x8mm)
Ply (15x15x6mm)
7
Epoxy plies under the canopy and assemble the
canopy to fuselage with screw.
Wooden Block(43x28x26mm)
1
Gear door
2
4
Collar (5mm)
Wheel (100mm)
Landing gear
2
1
8
2
TP Screw (3x20mm )
Landing gear straps
(5mm)
4
TP Screw (2.6x14mm)
8
Washer (3x6mm)
2
Wooden Block(25x15x13mm)
TP Screw (2.3x12mm)
Wooden Block
TP Screw (2.6x14mm)
Collar (5mm)
Wooden supporter
Note:rubber wheels oleo struts
and retracts are optional.
Install the wheel to the fixed landing gear.
Epoxy the fixed landing gear to the main wing.
66
68
67
13
65
69
Accessory list for the coming installation steps.
Accessory list for the coming installation steps.
