Troy-Bilt Super Bronco 60TG, Руководство оператора

Страница: 9 / 48

9
Figure 3
3
Attaching The Steering Wheel
The hardware for attaching the sterring wheel has been
packed within the steering wheel, beneath the steering
wheel cap. Carefully pry off the steering wheel cap and
remove the hardware.
NOTE
: There are two different styles of steering wheel
cap. See Figure 3.
Styles vary by model.
1. With the wheels of the tractor pointing straight
forward
, place the steering wheel over the steering
shaft.
2. Place the washer (with the cupped side down) over
the steering shaft and secure with the hex bolt. See
Figure 3.
3. Place the steering wheel cap over the center of the
steering wheel and push downward until it “clicks” into
place.
Gas and Oil Fill-up
The gasoline tank is located under the hood and has a
capacity of three gallons. Do not overfill.
WARNING: Use extreme care
when handling gasoline. Gasoline
is extremely flammable and the
vapors are explosive. Never fuel
machine indoors or while the
engine is hot or running. Extin-
guish cigarettes, cigars, pipes,
and other sources of ignition.
Service the engine with gasoline and oil as instructed in
the separate Kohler Operator/Owner Manual packed with
your tractor. Read instructions carefully.
IMPORTANT
: Your tractor is shipped with motor oil in the
engine. However, you MUST check the oil level before
operating. Be careful not to overfill.
Shipping Brace Removal
WARNING: Make sure the riding
mower’s engine is off, remove the
ignition key, and set the parking
brake before removing the ship-
ping brace.
• Locate the shipping brace, if present, and accompany-
ing warning tag found on the right side of the mower,
between the discharge chute and the cutting deck.
See Figure 4.
• While holding the discharge chute with your left hand,
remove the shipping brace with your right hand by
grasping it between your thumb and index finger and
rotating it clockwise.
WARNING
Make sure the riding
mower’s engine is
off, remove the igni-
tion key, and set the
parking brake before
removing the shipping
brace.
Setting Up
Your Lawn
Tractor
The shipping brace,
used for packaging
purposes only, must
be removed and
discarded before
operating your riding
mower.
The mowing deck is
capable of throwing
objects. Failure to
operate the riding
mower without the
discharge cover in
the proper operating
position could result
in serious personal
injury and/or property
damage. Figure 4
WARNING: The shipping brace,
used for packaging purposes
only, must be removed and
discarded before operating your
riding mower.
WARNING: The mowing deck
is capable of throwing objects.
Failure to operate the riding
mower without the discharge
cover in the proper operating
position could result in serious
personal injury and/or property
damage.