Troy-Bilt Super Bronco 60TG, Руководство оператора

Страница: 8 / 48

8
3
Setting Up
Your Lawn
Tractor
NOTE
: This Operators Manual covers a range of product
specifications for various models. Characteristics and fea-
tures discussed and/or illustrated in this manual
may not
be applicable to all models. MTD LLC reserves the right
to change product specifications, designs and equipment
without notice and without incurring obligation.
Attaching the Battery Cables
NOTE : The positive battery terminal is marked Pos. (+).
The negative battery terminal is marked Neg. (–).
• The positive cable (heavy red wire) is secured to the
positive battery terminal (+) with a hex bolt and hex
nut at the factory. Before attaching the negative cable,
remove the battery by removing the positive cable
and hold-down strap. Note the date on the side of the
battery. If the battery is put into service after this date,
charge the battery as instructed in the Maintaining
Your Lawn Tractor section of this manual prior to
operating the tractor.
• Secure battery back onto the tractor with the hold-
down strap. Reattach the positive cable (heavy red
wire) to the positive battery te) with the bolt
and nut. Make certain that the rubber boot covers the
terminal to help protect it from corrosion.
• Remove the hex bolt and hex nut from the negative
cable.
• Remove the black plastic cover, if present, from the
negative battery terminal and attach the negative
cable (heavy black wire) to the negative battery
terminal (–) with the bolt and nut.
• Make certain the hold-down strap is in position over
the battery, securing it in place. See Figure 1.
Attaching The Seat
NOTE : For shipping reasons, seats are either fastened
to the tractor seat’s pivot bracket with a plastic tie, or
mounted backward to the pivot bracket. In either case,
free the seat form its shipping position and remove the
two hex screws (or knobs, on models so equipped) from
the bottom of seat before proceeding with applicable
instructions below.
1. Position the shoulder screws (found on the base of the
seat) inside the slot openings in the seat pivot bracket.
Figure 2.
2. Slide the seat slightly rearward in the seat pivot
bracket, lining up the rear slots in the pivot bracket
with the remaining two holes in the seat’s base.
3. Select desired position for the seat, and secure with
the two knobs removed earlier. See Figure 2.
Figure 1
�����������
��������
�������
WARNING
Use extreme care
when handling
gasoline. Gasoline is
extremely flammable
and the vapors are
explosive. Never fuel
machine indoors
or while the engine
is hot or running.
Extinguish cigarettes,
cigars, pipes, and
other sources of
ignition.
NOTE: This Operators
Manual covers a range
of product specifications
for various models.
Characteristics and
features discussed
and/or illustrated in
this manual
may not be
applicable to all models.
MTD LLC reserves the
right to change product
specifications, designs
and equipment without
notice and without incur-
ring obligation.
Figure 2