Troy-Bilt 25A-304-766, Руководство оператора

Страница: 30 / 96

30
STORAGE
Long-term Storage
1. Remove the fuel cap, tip the unit and drain the fuel into an approved container. Reinstall the fuel cap.
2. Start the engine and allow it to run until it stalls. This ensures that all fuel has been drained from
the carburetor.
3. Allow the engine to cool. Remove the spark plug and put 5 drops of any high-quality motor oil into
the cylinder. Pull the starter rope slowly to distribute the oil. Reinstall the spark plug.
4. Thoroughly clean the unit and inspect it for any loose or damaged parts. Repair or replace
damaged parts and tighten loose screws, nuts or bolts.
Preparing the Unit for Use after Long-term Storage
1. Remove the spark plug. Tip the unit and drain all of the oil from the cylinder into an approved
container. Reinstall the spark plug.
2. Change the oil. Refer to Changing the Oil .
NOTE: Do not use fuel that has been stored for more than 30 days. Dispose of old fuel and oil
according to federal, state and local regulations.
CLEANING AND STORAGE
CLEANING
• Use a small brush to clean the outside of the unit.
• Do not use strong detergents. Household cleaners that contain aromatic oils such as pine and
lemon, and solvents such as kerosene, can damage plastic.
• Wipe off any moisture with a soft cloth.
• Clean the edger blade with water. Wipe the edger blade with a light machine oil to prevent rust.
WARNING:
To avoid serious personal injury, always stop the engine and allow it to
cool before cleaning or maintaining the unit.
WARNING:
Store the unit out of the reach of children. Lock up the unit to prevent
unauthorized use or damage.
WARNING:
Store the unit in a dry, well-ventilated area. Never store a fueled unit
where fumes may reach an open flame or spark. Allow the engine to cool before storing.