Troy-Bilt 25A-304-766, Руководство оператора

Страница: 18 / 96

18
STARTING AND STOPPING
WARNING:
Operate this unit only in a well-ventilated outdoor area. Carbon
monoxide exhaust fumes can be lethal in a confined area.
WARNING:
Avoid accidentally starting the unit. To avoid serious injury, the operator
and the unit must be in a stable position when pulling the starter rope (Fig. 11).
WARNING:
The blade may rotate during the starting process. Always stand in the
starting position. Use one foot to hold the wheels in place. Tilt the unit back slightly to
bring the blade off the ground.
STOPPING INSTRUCTIONS
1. Release the throttle control and allow the engine to idle.
2. Press and hold the On/Off switch in the Off (O) position until the engine comes to a complete stop
(Fig. 9).
STARTING INSTRUCTIONS
NOTE: There is no need to turn the unit on. The On/Off switch is in the On ( I ) position at all times (Fig. 9).
Before Starting the Unit
1. Check the oil level. Refer to Checking the Oil Level .
2. Fill the fuel tank. Refer to Fueling the Unit .
Starting the Unit
1. Slowly press and release the primer bulb 10 times (Fig. 10).
2. Stand in the starting position (Fig. 11). Hold the handlebar firmly with one hand. Hold the starter
rope with the other hand. Use one foot to hold the wheels in place.
3. Tilt the unit back slightly to bring the blade off the ground.
4. Squeeze and hold the throttle control (Fig. 9).
5. Continue to hold the throttle control. Pull the starter rope with a controlled and steady motion
until the unit starts (Fig. 11).
IF... the engine does not start after pulling the starter rope 10 times, repeat the starting procedure.
IF... the engine fails to start after 3 attempts, begin the starting procedure with step 2.
IF... the engine stops while the throttle control is squeezed, repeat the starting procedure.
IF THE ENGINE IS HOT... repeat the starting procedure.